You are here: Home / News / Introduction to other stone surface processing methods

Introduction to other stone surface processing methods

Views:0     Author:Site Editor     Publish Time: 2022-01-03      Origin:Site

Introduction to other stone surface processing methods

1. Fireproof board

The fire board is the uneven surface formed by the flame burning on the surface of the stone. The processing cost of the fired board is about 3.5 yuan (the processing cost of the soft board is slightly higher)



2. Lychee noodles

The lychee noodle is processed into an uneven surface by the lychee cutter head. The processing cost of lychee noodles is about 3.5 yuan (manual), the automation equipment is about 3 yuan/square, and the processing price of hard board is about 5-6 yuan.



3. Frosted board

The matt board treatment makes the surface of the stone appear matt, and the luminosity is generally below 25 degrees. Generally, it is processed to about 320 with ordinary abrasive, and then processed with antique brush 120/240#.


4. Antique noodles

After the surface of the stone is treated with fire or lychee cutter head, use a wire brush to remove some debris and sharp corners on the burning surface, and then use an antique brush to make the surface of the stone have an antique effect. The general ratio is:


Wire brush, antique brush 36#, 46#, 60#, 80#, 120#, 180#, 240#, 320#. If you need a higher luminosity, you can increase the size of the antique brush, the smallest can reach about 800.


The hand grinder can appropriately reduce the particle size of the antique brush, reduce the number of times to replace ABRASIVES FOR STONE, and improve efficiency.


The antique brush filament is composed of silicon carbide particles and nylon. They have a disc shape, a horseshoe shape and a bra shape. The life of a general brush is about 100-200 square meters, and the height of the brush wire is 3-3.5cm.



The leather surface is processed directly, usually using a diamond brush to make the

5. Leather surfacestone surface look like a leather surface. The general ratio is:


King Kong Brush 36#, 46#, 60#, 80#, 120#, 180#, 240#, 320#. If you need a higher luminosity, you can increase the size of the antique brush, the smallest can reach about 800.


The hand grinder can appropriately reduce the particle size of the diamond brush, reduce the number of grinding times, and improve efficiency.


The diamond wire is composed of diamond particles and nylon. Diamond brushes are much more abrasive than antique brushes, so they are not suitable for processing softer plates such as marble into leather. The role of diamond brush and wire brush in polishing the antique surface is to increase the three-dimensional effect



GET IN TOUCH